![]() Overfilling the bottle will force coolant out of the engine as it warms up. Remove the cap from the engine and wait for half the bottle to fill before adding coolant here. The clear reservoir with a black cap on top of this heater hose has a clear reservoir plumbed into it. The coolant reservoir is located in the back of the engine compartment in the right rear corner. I have no radiator cap, and I am unable to find a secondary fill tank for my 1990 Jeep. Where do you fill the coolant tank in a Jeep Cherokee? This is the first time I have submitted it since 2006. Over time, the coolant will become contaminated and will need to be replaced. Also, be sure to follow the manufacturer’s recommendations for the coolant change interval. Using the wrong type of coolant can damage the engine. Be sure to use the correct type of coolant in your Jeep Cherokee. If the level is low, add coolant until it reaches the “Full” line. ![]() The coolant level should be at or above the “Full” line on the reservoir. Locate the coolant reservoir, which is usually located near the radiator. To check the coolant level, Park the Jeep on level ground and open the hood. The 2.4-liter engine uses a 50/50 mix of ethylene glycol antifreeze and water, while the 3.6-liter engine uses a Dex-Cool extended-life coolant. The type of coolant used in each engine is different. Jeep Cherokees are equipped with either a 2.4-liter four-cylinder engine or a 3.6-liter V6. It is important to use the correct type of coolant in a Jeep Cherokee, as well as to follow the proper procedure for adding coolant. The coolant level should be checked regularly, and topped off when necessary. A Jeep Cherokee needs coolant to keep its engine from overheating.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |